Ending Voice Dialogue Prematurely; Voice Entries - Becker Traffic Pro 7949 Operation Manual

Hide thumbs Also See for Traffic Pro 7949:
Table of Contents

Advertisement

Notes:
You can activate or deactivate the
sounding of the signal tone as described
in "Automatic dialogue" on page 96.
X
Read out the required command.
The Traffic Pro carries out the required
command.
If for example you call up a menu with
the command, voice mode remains
active and you can enter another com-
mand immediately.

Ending voice dialogue prematurely

A voice dialogue can be ended at any
time.
Read out one of the following
X
commands: Cancel or End.
or
X
Press the rotary control/push button
.
A voice dialogue can also be continued
by means of an operator input on the
unit.
However, to continue operation in voice
mode, the rotary control/push button
must then be pressed again.
Voice mode

Voice entries

Depending on the setting in "Voice
entries" on page 107 for radio mode and
in "Voice entries" on page 91 for the
address book, when storing a station or
address book entry, at the end of the
process voice mode will ask you if you
wish to enter a voice command.
This teaches voice mode how you usually
pronounce the name. This enables you to
subsequently call up a radio station, for
example, with the voice command Play
station ...* (where ...* stands for the
assigned name, e.g. SWR).
The same applies to address book entries:
If you have assigned a voice entry to an
address, you can start route guidance to
...* with the voice command Navigate to
destination ...* (where ...* stands for the
assigned name, e.g. Franz Huber).
107

Advertisement

Table of Contents
loading

Table of Contents