Operation; Spreader/Riving Knife Positions - Performax 240-3600 Operator's Manual

10” table saw with stand
Table of Contents

Advertisement

WARNING:
table saw against the stand, make sure
the two outside legs which are inserted
into the limit-support are below the back
of the table saw as shown in fig. 3b.
STORING ACCESSORIES
The table saw has two convenient storage
areas specifically designed for accessories
(one on either side of the saw cabinet):
Miter gauge, Wrench, blade and Push stick
Store accessories securely when they are
not in use.
REMOVING/REPLACING THE
THROAT PLATE (FIG. 4)
FIG. 4
1 . Unplug the saw .
2 . Lower the blade by turning the height-
adjusting handle counter-clockwise .
3 . To remove the throat plate, place your
index finger in the hole and lift the front
end, then pull the throat plate out
toward the front of the saw .
4 . To reinstall the throat plate, slip the
tab into the slot at the back of the saw
and push down to secure it in place .
Page 13
ASSEMbLy
When you position the
SPREADER/RIVING KNIFE
POSITIONS (FIG. 5-6)
FIG. 5
FIG. 6
This saw is shipped with the spreader/riving
knife placed in the non-through cutting or
"down" position (riving knife position) .
NOTICE: The spreader/riving knife must be
placed in the through-cutting or "up"
position (spreader position) for all other
cutting operations .

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents