Product Specifications - Ryobi OLT1830 Operator's Manual

RULES FOR SAFE OPERATION
WARNING:
If any parts are missing, do not operate unit until the
missing parts are replaced. Failure to do so could
result in possible serious personal injury.
SAVE THESE INSTRUCTIONS. REFER TO THEM
FREQUENTLY AND USE THEM TO INSTRUCT OTHERS
WHO MAY USE THIS UNIT. IF YOU LOAN SOMEONE THIS
UNIT, LOAN THEM THESE INSTRUCTIONS ALSO.

PRODUCT SPECIFICATIONS

Motor 18V DC
No load speed ................................................. 9000 min -
Battery Pack ............................................................... 18V
Charging Rate ......................................................... 2 hour
String Head ......................................................Bump Head
Cutting Line Diameter ...........................................1.65 mm
Cutting Path Diameter ...........................................230 mm
Weight with Battery pack ..........................................2.6 kg
Battery pack (not included) ... ...................... BPP-1817M /
................................... BPP-1815M /ABP1801 / ABP1802 /
............................ BPP-1817MG / BPL-1820 / BPL-1820G
Charger (not included) ............ ... BC-1800 / BC-1800M /
................................................BC-1815S / BC-1815SMG /
...................................ACR1800 / BCL-1800 / BCL-1800G
FEATURES
Fig. 1
A. TRIGGER LOCK BUTTON
B. SPOOL HOLDER FOR ADDITIONAL SPOOL
C. FRONT HANDLE
D. SHAFT ADJUSTIMENT COLLAR
E. MOTOR HOUSING
F. CUT OFF BLADE
G. BATTERY PACK (NOT INCLUDED)
H. REAR HANDLE
I. TRIGGER
J. GRASS SHIELD
K. CUTTING LINE
L. EDGING COUPLER
M. EDGING WIRE
Fig. 2
A. GRASS SHIELD
ENGLISH
B. MOTOR HOUSING
C. REMOVE BOTH SCREWS
D. RE-INSTALL BOTH SCREWS
Fig. 3
A. FRONT HANDLE
B. FASTEN KNOB
C. BOLT
D. FLAT WASHER
Fig. 4
A. TO UNLOCK COLLAR
B. SHAFT ADJUSTMENT COLLAR
C. LOWER PORTION OF SHAFT ADJUSTMENT
COLLAR
Fig. 5
A. SLIDE OUT TO DESIRED POSITION
Fig. 6
A. SHAFT ADJUSTMENT COLLAR
B. LOWER PORTION OF SHAFT ADJUSTMENT
COLLAR
1
C. TO LOCK COLLAR
Fig. 7
A. BATTERY PACK (NOT INCLUDED)
B. LATCHES
Fig. 8
A. TRIGGER LOCK BUTTON
B. TRIGGER
Fig. 11
A. CUT OFF BLADE
Fig. 14
A. BUMP KNOB
B. SLOT ON SPOOL
C. SPOOL CAP
D. TABS
E. SPOOL
F. SPRING
G. SPOOL HOUSING SLOT
H. OPENING IN SPOOL HOUSING
I. SPOOL HOUSING
INSTALLING THE GRASS SHIELD
■ Remove both screws on the motor housing. Orient grass
shield on the motor housing and twist to lock in place as
shown.
■ Re-install screws to secure grass shield in place. See
Figure 2.
ATTACHING THE FRONT HANDLE
■ Press the front handle onto the shaft. See Figure 3.
Page 4
ASSEMBLY