Chassis Setup And Maintenance; Removing The Chassis Cover; Installing Hard Drives; Removing Hard Drive Trays - Bosch DIVAR IP 6000 1U Installation Manual

14 en | Chassis setup and maintenance
3

Chassis setup and maintenance

This chapter covers the steps required to install components and perform maintenance on the
chassis.
Caution!
Review the warnings and precautions listed in the manual before setting up or servicing this
!
chassis.
3.1

Removing the chassis cover

To remove the chassis cover:
1.
2.
3.
4.
Notice!
Except for short periods of time, do NOT operate the server without the cover in place. The
chassis cover must be in place to allow proper airflow and prevent overheating.
3.2

Installing hard drives

This chapter describes the removing and installing of hard drives.
3.2.1

Removing hard drive trays

The drives are mounted in drive carriers to simplify their installation and removal from the
chassis. These carriers also help promote proper airflow for the drive bays.
2014.01 | V2 | DOC
Remove the two screws on each side of the cover, which secure the cover to the chassis.
Press the release tabs to remove the cover from the locked position. Press both tabs at
the same time.
Once the top cover is released from the locked position, slide the cover toward the rear
of the chassis.
Lift the cover off the chassis.
Installation manual
DIVAR IP 6000 1U
Bosch Sicherheitssysteme GmbH