How To Swing The Control Box To The Front - Mitsubishi Electric EHSD-MEC.UK Service Manual

DISASSEMBLY PROCEDURE

4. How to swing the control box to the front

(1) Remove the front panel. (Refer to Procedure 1.)
(2) Remove the screw from the control box bracket (R) and 2
screws from the control box bracket (L).
(3) Release the coated clamp.
(4) Disengage the control box bracket (R) from the right-hand
side panel and pull the control box. At this point, lifting
slightly and pulling the control box will swing the control
box to the front. (Photo 4-2)
Note: Remove the field wiring as necessary.
OCH571
PHOTOS
Photo 4-1
Screws
Coated clamp
* The photos shown are of the EHSC-YM9C model.
Photo 4-2
Control box
Swing
60
Earth cable
Side panel
Screw
Bracket
(R)