Brother DCP-1600E User Manual page 27

Chapter 1
2.Fax (For MFC-1900(E) and MFC-1905) (continued)
Level 2 Level 3
1.Setup 4.Auto
Receive Reduction
(In FAX mode
only)
(Continued)
5.Memory
Receive
6.Print
Density
The factory settings are shown in Bold with an asterisk.
20
Descriptions 1
The machine
calculates the
reduction ratio by
using the page size of
the fax and your
Paper Size setting
(Menu, 1, 2, 2).
Automatically stores
any incoming faxes in
2
its memory if it runs
out of paper.
The machine will
carry on receiving the
current fax, with the
remaining pages
being stored in
memory, if enough
memory is available.
You can adjust the
Print Density setting
3
to make your printed
pages darker or
lighter.
Options Descriptions 2
If you choose On, the
On*
machine
automatically
reduces each page of
an incoming fax to fit
on one page of A4,
Letter, Legal, Folio,
A5, A5(Long Edge),
B5 or Executive size
paper.
Off
Further incoming
On*
faxes will also be
stored into memory
until the memory is
full. When the
memory is full the
machine will stop
automatically
answering calls. To
print the faxes, put
fresh paper in the tray
and press Start.
Further incoming
Off
faxes will not be
stored in memory.
The machine will
then stop
automatically
answering calls until
fresh paper is put in
the paper tray. To
print the last fax you
received, put fresh
paper in the tray and
press Start.
Press c to make
-nnnno+
darker, press d to
-nnnon+
make lighter.
-nnonn+*
-nonnn+
-onnnn+
Page