Acer P5403 series User Manual page 35

Security
Downloaded From projector-manual.com Acer Manuals
Security
This projector provides a useful security function for the
administrator to manage the projector.
Press to change the "Security" setting. If the security
function is enabled, your must enter "Administrator
Password" first before changing the security setting.
The factory default of "Administrator Password" is
"1234".
Select "On" to enable the security function. You have to
•
enter password depending on the "Security Mode".
Please refer to "User Password" section for details.
If "Off" is selected, you can switch on the projector
•
without password.
Timeout (Min.)
Once "Security" is set to "On", you can set timeout function.
Press to select timeout duration.
•
The range is from 10 to 990 minutes.
•
When time is up, the projector will request you to enter
•
the password again.
The factory default setting of "Timeout (Min.)" is "Off".
•
Once the security function is enabled, the projector will
•
request you to enter password when switching on the
projector. Both "User Password" and "Administrator
Password" can be accepted for this dialogue.
User Password
Press to set up or change "User Password".
•
Use the numerical keys on the remote control to set the
•
password and press "MENU" to confirm.
To delete the digits, Press
•
Enter the password again when you see "Confirm
•
Password" displayed.
The password should be 4~8 digits in length.
•
If you select "Request password only after plugging
•
power cord", you are requested to input the password
every time the power cord is plugged.
If you select "Always request password while projector
•
turns on", you are requested to input the password every
time the projector is turned on.
.
25