Acer P5403 series User Manual page 38

28
LAN Setting
(for P5403/
N243/PN-SX12)
LAN Reset
(for P5403/
N243/PN-SX12)
LAN
(for S5201M/
T111B/PS-X11M)
Downloaded From projector-manual.com Acer Manuals
To connect your projector to the network:
1 Take a RJ45 cable and connect one end to the LAN input
jack of the projector and the other end to the RJ45 port.
2 Enter the LAN Setting menu. The
Password" dialogue box is displayed.
3 Enter "Administrator Password". The next level menu
is displayed.
The factory default of "Administrator Password" is
"1234". You can change it in the Setting > Security >
Administrator Password menu.
4 Select LAN in this menu and press
5 Make sure DHCP is on, and press
press .
6 Re-enter the menu and note down the IP address
displayed in the row of Projector IP Address.
If your are not in a DHCP environment, set DHCP to "Off" and
contact your ITS administrator for information on Projector IP
Address, Subnet Mask, Default Gateway, and DNS Server.
1 Press to select Projector IP Address and press
2 Press to move the cursor and press
enter the digits.
3 When you finish, press MENU to save and exit the menu.
4 Repeat steps 1-3 to input addresses for Subnet Mask,
Default Gateway, DNS server.
5 Press to highlight Apply and press
To control the projector remotely:
1 Enter the Projector IP address in the address bar of the
web browser on your computer.
2 The remote network operation page is displayed.You can
control the projector by using this page. For details, see
the notes following this table.
Press after choosing "Yes" to return all items on the Tools
page to the default settings.
The default value is "Off". Choose "On" to enable the
•
LAN connection.
"Enter Administrator
to select "On".
to select Apply and
.
to
.