Roadgear
Components
RoadGear 160
Two Speakers with specially molded enclosures
●
One powered mixer built into a specially molded storage case
●
One Phonic UM 99 microphone with 20 foot (6 meter) cable, clip and pouch.
●
Two 30 foot (9 meter) speaker cables
●
Detatchable power cable
●
One transparent dust cover
●
RoadGear 260
Two Speakers with specially molded enclosures
●
One powered mixer built into a specially molded storage case
●
Two Phonic UM 99 microphones, each with a 20 foot (6 meter) cable, clip and pouch.
●
Two 30 foot (9 meter) speaker cables
●
Detatchable power cable
●
One transparent dust cover
●
!
Caution
Use the AC power cable supplied with the RoadGear sets only.
●
When buying the RoadGear, the AC power cable will be specific to the safety and code requirements of the
●
Country of purchase.
The ground (earth) pin of the AC power cable's male connector should under no circumstances be
●
removed.
When taking the RoadGear abroad, check the local voltage and ensure an appropriate power level is used,
●
as selected by the power selection switch on the back panel. (eg. If the local standard is between 100 and
120 Volts, the 115 volt power level should be selected. If the standard is between 220 and 240, then 230
volts should be selected).
When the RoadGear is in use, the storage compartment door must be kept open for better ventilation.
●
PHONIC CORPORATION
RoadGear User's Manual
page 5