Some Important Information; The Combination Docking Lock; Latch Position - Phonic Road Gear 160 User Manual

Some Important Information

The Combination Docking Lock

The docking locks of the RoadGear are combination locks, which require the user to enter a pre-set
combination to open them. Please observe the following instructions to opening the lock.
1) The default code of the lock is 000. Please enter this code the first time you use the RoadGear.
2) To change the lock's code, first open the latch and find a small lever on the underneath of the lock.
Pull it towards the centre of the lock and up until it sticks into place.
Underneath The RoadGear Combination Lock
3) Change the code dials to your desired secret code. Ensure you either remember the code by heart
or write it down somewhere, so as to not have to attempt to break the RoadGear apart in a way that
would not be favorable to your equipment.
4) After entering your desired code, replace the small lever underneath the lock into its original posi-
tion. And Voila! Your new, secret code is set.

Latch Position

Please ensure, after unpacking the RoadGear set, that the docking locks on the speakers are locked
back into place, to ensure the locks do not scratch the surface on which the speaker is standing.
page 13
PHONIC CORPORATION RoadGear User's Manual