Disassemble Color Wheel Module And Photo Sensor Board; Disassemble Dmd Chip And Dmd Board - Sanyo PDG-DXL100 Service Manual

2-14 Disassemble Color
Wheel Module and
Photo Sensor Board
1. Unscrew 2 screws (as red circle) to
disassemble the Color Wheel Module.
2. Unscrew 1 screw (as yellow circle) to
disassemble the Photo Sensor Board
from the Color Wheel Module.
Note: - Avoid touching the glass parts of color
wheel.
2-15 Disassemble DMD Chip
and DMD Board
1. Unscrew 2 screws (as red circle) to
disassemble the Heat Sink and DMD
Module.
2. Counterclockwise rotate the screw (as
yellow circle) to disassemble the DMD
Board and DMD Chip.
Note: - Avoid touching the DMD Chip when you
disassemble it.
- Found that the DMD Chip has scrapes
or dirt use of a magnifying glass, you
may use an electrostatic ion gun to
clean it.
- Pay attention to the fixed position when
assembling the DMD Chip.
PDG-DXL100 Confidential 2-11