Factory Settings Pg - Zynex Medical E-wave User Manual

Return to factory settings: Press PRG eleven times and the display
will prompt the choice to reset all parameters to factory settings. This
is particularly useful if the user is unsure if the settings are correct and
is a good starting point for variations.
Factory settings are:
Frequency: 30Hz
Pulse width: 200 µsec.
On-Time: 6 seconds
Off-Time: 6 second
Ramp Up: 1 second
Ramp Down: 1 second
Timer: Continuous
Using the External Trigger Input: A standard external trigger, such
as a heel-switch, can be connected through the connector on the left
side of the unit. The Off-time is now disabled and a stimulation cycle
will only begin, when the switch is activated. The set parameters for
On-time, Ramp Up and Down will be in effect for a stimulation cycle.
This functionality is enabled as soon as the connector is inserted into
the E-Wave.
Page 6