Cleaning The Head Part; Setting The Cutting Power - ceylan DEVRAN User Manual

USER MANUAL

9. Cleaning the head part

Blocking
pin
Do not clean the entire device in water or in a dishwasher!
- Caution! Make sure that there is no entry of liquids into
(Use of device without the protective part is forbidden.)
10. Adjust and clean of the thickness regulator
1- At least after a daily use, the device have to be
cleaned.
2- During the cleaning process, keep the device off!
3- Pull away the cutting handle part device from the
mains device.
4- Open the cover by unscrewing the bolt.
5- Place the blocking pin in the whole of the blade.
6- Turn the bolt with a screwdriver. Now you can
remove the blade carefully and start the cleaning.
Never remove the head part!!!
Do not remove the head part in the handle part!
Otherwise, you will have problems in assembly.
the engine part. Do not remove the protective part!
It is forbidden to grease the head part!!!
You can adjust the cutting size with the
regulator screw. (see picture) During cleaning,
Regulator
the thickness regulator should be removed
screw
from the device.
Cleaning the thickness regulator:
1- First turn off the device
2- Remove the cover and blade carefully
3- Adjust the setting screw at the highet position
4- Unscrew the lateral fi xing screws of the
5- Take off the thickness regulator backward
Caution!
Regulator
After the cleaning there should be no
screw
remainders of detergents.
thickness regulator
For the cleaning washing detergents are
allowed to use.
Technical Support
27