Advertisement
9
Using the Spin-Start
Put the standard hex end (with the O-ring) of the starter shaft
into the Spin-Start. Slide your hand under the strap of the
starter so that your index finger is on the switch at the bottom.
Place the machined end of the starter shaft into the matching
hex socket in the backplate of the engine. Holding the starter
securely, press on the switch button and the engine should
turn over and start up. If the engine does not turn over, it is
probably flooded or the battery in the starter needs to be
Stopping the Engine
10A
When you are done running your Limited Edition Aftershock,
push the primer button down to stop the engine (fig.10A).
It may be necessary to push the primer button down
several times. If the engine does not stop, use the handle
of a screwdriver or a rag to cover the exhaust pipe exit
(fig.10B), being EXTREMELY careful not to burn your hand as
this will be hot.
©2010 Losi, a division of Horizon Hobby, Inc.
Printed 10/09
Page 4
17203
recharged. Use a glow plug wrench to loosen the glow plug at
least two turns and try again.
Raw fuel should come out around the plug. Tighten the plug
and resume the starting procedure. Follow the engine break-in
procedure before attempting any racing or high-performance
operation. Use caution when adding fuel while the engine is
running. Do not over-fill or spill fuel outside the tank.
Caution HOT!
10B
800-0404
Advertisement
