Deleting All Markings; Playback With Av Equipment Y Video Out - Leica DIGILUX 2 Instructions Manual

Deleting all markings – CANCEL ALL
3. Open the relevant viewfinder/monitor screen and
follow the further menu instructions.
Note: The flashing arrow pointing to the right only
appears if the corresponding markings exist. If
there are none, it is not possible to access the sub-
menu and the subsequent steps.
• In the viewfinder/monitor, the sub-menu to
cancel all DPOF markings for the presentation
appears, and the original viewfinder/monitor
screen appears after leaving the menu system.
PLayback with AV equipment - Y VIDEO OUT
The LEICA DIGILUX 2 allows you to view or present
your pictures on a TV or computer monitor, and there-
fore on a large screen. This also applies to all sound
recordings, which can be played back on an audio
system. The camera is connected to the TV via the
A/V lead supplied, after it has been set to the TV
standard applicable in your country – PAL or NTSC.
172 / Detailed guide / Review mode
The camera's monitor screen ("Livecam") can also be
reproduced on NTSC compatible TVs or computer
monitors with a video input. The same applies to
(brief) automatic or manual review of the picture just
taken in the record modes (B AUTO REVIEW/
VIEW).
Notes:
• Do not use any leads other than the one supplied.
• If your TV has a scart socket rather than a cinch
socket, you will also need an appropriate adapter.
• We recommend that you run the camera from the
mains for this application (see p. 118)
• Please refer to the relevant manual for details of
the required TV settings.
Selecting the TV standard
In the basic review menu k SETUP
pp. 113/122) select the menu item Y VIDEO OUT
(3.35) and follow the further menu instructions.
Connecting/Playing back pictures
1. Turn off the camera and the TV.
2. Plug the small individual strip plugs of the lead into
the camera's "A/V OUT/REMOTE" socket (1.35)
and plug the cinch plugs into the relevant sockets
on the TV: the yellow plug in the video in socket,
the white one in the audio in socket.
2
/ (see
3
3. Turn on the TV and switch to the AV channel.
4. Turn on the camera and set the Record/review
selector (1.15) to review 8.
• The image set on the camera is then reproduced
on the TV.