Related Manuals for Digi HR4420i
Summary of Contents for Digi HR4420i
- Page 1 4000 Series Routers Wireless GPRS/EDGE/UMTS/HSDPA/HSUPA router / switch Installation Guide...
- Page 2 Digi International reserve the right to modify or revise all or part of this document, its contents, and any products described herein at any time without prior notification and shall not be responsible for any loss, cost, or damage, including consequential damage, caused by reliance on these materials.
- Page 3 Any attempt to service or repair the unit by the user will void the product warranty. The HR4420, HR4420i and HR4420p are designed for indoor use only and should be used in an environment that is suitable for computers and other electronic equipment.
- Page 4 However, wireless based products contain radio devices which require specific consideration. Please take the time to read and understand the following guidance. Digi International assumes no liability for an end user‟s failure to comply with these precautions.
- Page 5 HR4420/i/p Installation Guide Preface This guide describes the installation procedure for the HR4420, HR4420i and HR4420p. It is intended to provide sufficient information for you to be able to connect the unit to your terminal equipment and power supply. A complete reference guide to the software features that are available on the product is available separately in PDF format that can be downloaded from the Digi International website (www.digi.com).
-
Page 6: Front Panel Features
The front panel of the unit incorporates the USB host connectors, a number of LED indicators depending on the model and the two SIM card-holders as shown in the following illustration (HR4420i): USB Host Connectors The USB host connectors may be used to connect compatible USB client devices such as... - Page 7 3 LED‟s illuminated >= -70dBm and <= -51dBm (strong) ISDN: On the HR4420i, these indicators operate as follows: D, B1, B2 D – Illuminates green when the unit is connected to an ISDN network and the D-channel signalling layer is active.
- Page 8 HR4420/i/p Installation Guide SERIAL: These indicators operate in one of two software configurable modes: 0, 1 Connection Mode: Illuminate steady if a terminal is connected to the serial port and the DTR signal is on. Flash when data is transmitted or received. DTR Mode: Flash when data is transmitted or received only.
-
Page 9: Installation
Digi International can supply a range of suitable aerials. Important: If you are going to be using the Sar/OS Connection Wizard to configure the unit‟s Ethernet port and also connect it to your GSM/3G network, skip this section and... - Page 10 HR4420/i/p Installation Guide Step 2 – Fitting the antenna The router is supplied with a “stub” aerial and an elbow adapter for use with wireless networks. There are two options for fitting the antenna: If the unit is to be mounted on a flat surface such as a desktop, you should first screw the antenna onto the 90...
- Page 11 Step 1 – Install the Connection Wizard Download the connection wizard from the Digi website and install the software on your PC. Step 2 – Run the Wizard Once the wizard has been installed on your PC, run it from the Windows Start menu.
-
Page 12: General Specifications
HR4420/i/p Installation Guide 4 General Specifications Model numbers 81-HR4420-SSEU-00 (HR4420) 81-HR4420-SSEU-01 (HR4420i) 81-HR4420-SSEU-02 (HR4420p) Power supply 12V DC / 1.5A Dimensions W187 x D137 x H44 mm Weight 0.76Kg Operating temp. -20 to +50 degree Celsius range HR4420 - Category 5 2Mb HSUPA... -
Page 13: Declaration Of Conformity
HR4420/i/p Installation Guide 5 Declaration of Conformity Declaration of Conformity for R&TTE Directive Digi International Ltd, Beacon House, Riverside Business Park, Ilkley, West Yorkshire, LS29 8JZ, ENGLAND declare under our sole responsibility that the following product(s): Models: HR4420, HR4420i, HR4420p...
Need help?
Do you have a question about the HR4420i and is the answer not in the manual?
Questions and answers