Clarity C600 User Manual page 7

GETTING STARTED
TABLE/DESK TOP INSTALLATION
CAUTION: Disconnect the telephone line cord
before connecting or disconnecting the battery
backup in the wall mount bracket.
1. Plug one end of the supplied modular tele-
2. Plug the modular telephone line cord's other
3. Insert the supplied AC Adapter's plug into the
4. Plug the adapter into a standard 120V AC
5. Align the mounting bracket on the back of
6. Lift the base's antenna to a vertical position.
7. Set the TONE/PULSE switch located on the
8. Place handset in the cradle to begin
WALL MOUNTING INSTALLATION
CAUTION: Disconnect the telephone line cord
before connecting or disconnecting the battery
backup in the wall mount bracket.
The base unit may be mounted on a standard
wall plate.
12
phone line cord into the jack marked TEL
located on the back of the telephone base
as shown in the diagram.
end into a modular phone jack.
jack marked 9V DC 400mA located on the
back of the telephone base.
power (electrical) outlet.
the base so that the black rubber feet are
towards the bottom of the phone. Insert the
bracket's tabs into the slots and secure the
bracket by sliding it upward.
back of the base to correct dialing mode.
Please check with your local Phone Company
if uncertain of the type of service.
initial charging.
GETTING STARTED
1. Plug one end of the supplied short modular
telephone line cord into the TEL jack located
on the back of the base of the phone.
2. Insert the plug of the AC adapter into the
jack marked DC 9V 400mA located on the
back of the telephone base.
3. Align the mounting bracket on the back of
the base so that the black rubber feet are
towards the bottom of the phone. Insert the
bracket's tabs into the slots and secure the
bracket by sliding it upward.
4. Plug the short modular telephone line cord
into the wall plate jack, then align the mounting
bracket's keyhole slots with the wall plate
studs and slide the base of the phone down-
ward to secure it on the wall.
5. Plug the adapter into a standard AC power
(electrical) outlet.
6. Press and lift out the handset holder tab, turn
it around so the narrow tab end extends out
and slide back into its slot.This will hold the
handset in the cradle when the phone is
wall mounted.
7. Lift the base's antenna to a vertical position.
8. Set the Tone/Pulse switch located on the
end of the base to correct dialing mode.
Please check with your local Phone Company
if uncertain of the type of service.
9. Place handset in the cradle to begin initial
charging. Remember, you must charge the
phone for at least 12 hours before you use
the phone for the first time.
Note: Remember, you must charge the phone for
at least 12 hours before you use the phone for the
first time.
13