Specifications; Battery Removal/Installation - Hitachi WH 10DL Handling Instructions Manual

10. Do not use in a location where strong static electricity
generates.
11. If there is battery leakage, foul odor, heat generated,
discolored or deformed, or in any way appears abnormal
during use, recharging or storage, immediately remove it
from the equipment or battery charger, and stop use.
CAUTION
1. If liquid leaking from the battery gets into your eyes, do not
rub your eyes and wash them well with fresh clean water
such as tap water and contact a doctor immediately.
If left untreated, the liquid may cause eye-problems.

SPECIFICATIONS

POWER TOOL
No-load speed
Capacity (Ordinary bolt)
Tightening torque (Maximum)
Rechargeable battery
Weight
CHARGER
Model
Charging voltage
Weight
OPTIONAL ACCESSORIES (sold separately)
1. Battery (BCL1030A)
Optional accessories are subject to change without notice.
APPLICATIONS
○ Driving and removing of machine screws, wood screws,
tapping screws, etc.

BATTERY REMOVAL/INSTALLATION

1. Battery removal
Hold the handle tightly and push the battery latch to
remove the battery (see Figs. 1 and 2).
CAUTION
Never short-circuit the battery.
Rechargeable
battery
Remaining battery indicator lamp
4
Specifi cations for standard torque
UC10SFL
10.8 V
0.35 kg
Latch
Fig. 1
2. If liquid leaks onto your skin or clothes, wash well with
clean water such as tap water immediately.
There is a possibility that this can cause skin irritation.
3. If you fi nd rust, foul odor, overheating, discolor,
deformation, and/or other irregularities when using the
battery for the fi rst time, do not use and return it to your
supplier or vendor.
0 – 2300 / min
M5 – M12
110 N·m
BCL1030A: Li-ion DC 10.8 V (3.0 Ah 6 cells)
Handle
Pull out
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 2).
CHARGING
NOTE
The charger is an optional accessory that is sold
separately.
Before using the power tool, charge the battery as follows.
1. Connect the charger power cord to the receptacle
When connecting the plug of the charger to a receptacle,
the pilot lamp will blink in red (At 1-second intervals).
2. Insert the battery into the charger
Firmly insert the battery into the charger till it contacts the
bottom of the charger as shown in Fig. 3.
Specifi cations for low torque
0 – 2000 / min
65 N·m
1.2 kg
Latch
Insert
Push
Rechargeable battery
Fig. 2