Hitachi WH 10DL Handling Instructions Manual

Cordless impact driver

Advertisement

Cordless Impact Driver
Model WH 10DL (X)

Handling instructions

NOTE:
Before using this Power Tool, carefully read through these HANDLING
INSTRUCTIONS to ensure effi cient, safe operation. It is recommended
that these INSTRUCTIONS be kept readily available as an important
reference when using this power tool.

Advertisement

Table of Contents
loading

Summary of Contents for Hitachi WH 10DL

  • Page 1: Handling Instructions

    Cordless Impact Driver Model WH 10DL (X) Handling instructions NOTE: Before using this Power Tool, carefully read through these HANDLING INSTRUCTIONS to ensure effi cient, safe operation. It is recommended that these INSTRUCTIONS be kept readily available as an important...
  • Page 2: General Safety Rules

    Carrying power tools with your fi nger on the switch or GENERAL SAFETY RULES energising power tools that have the switch on invites accidents. WARNING! d) Remove any adjusting key or wrench before Read all instructions turning the power tool on. Failure to follow all instructions listed below may result in A wrench or a key left attached to a rotating part of the electric shock, fi...
  • Page 3: Caution On Lithium-Ion Battery

    b) Recharge only with the charger specifi ed by the 12. Do not dispose of the battery in fi re. manufacturer. If the battery is burnt, it may explode. A charger that is suitable for one type of battery pack 13.
  • Page 4: Specifications

    10. Do not use in a location where strong static electricity 2. If liquid leaks onto your skin or clothes, wash well with generates. clean water such as tap water immediately. 11. If there is battery leakage, foul odor, heat generated, There is a possibility that this can cause skin irritation.
  • Page 5 3. Charging Rechargeable battery When inserting a battery in the charger, the pilot lamp will light up continuously in red. When the battery becomes fully recharged, the pilot lamp will blink in red (At 1-second intervals). (See Table 1) (1) Pilot lamp indication The indications of the pilot lamp will be as shown in Table 1, according to the condition of the charger or the Insert...
  • Page 6: Prior To Operation

    CAUTION ○ If the battery is charged while it is heated because it has Trigger switch Selector button been left for a long time in a location subject to direct sunlight or because the battery has just been used, the pilot lamp of the charger lights for 1 second, does not light for 0.5 seconds (off...
  • Page 7: Operational Cautions

    (every 0.5 second), the battery may have a fault. tightening torque. So confi rm the actual tightening torque Please bring it back to your dealer or the Hitachi Authorized needed by screwing up some bolts before the job with a hand torque wrench.
  • Page 8: Maintenance And Inspection

    CAUTION Fig. 7 Repair, modifi cation and inspection of Hitachi Power Nail of carbon brush Tools must be carried out by a Hitachi Authorized Service Center. Protrusion of carbon brush This Parts List will be helpful if presented with the tool to the Hitachi Authorized Service Center when requesting repair or other maintenance.
  • Page 12 Sinagawa Intercity Tower A, 15-1, Konan 2-chome, Minato-ku, Tokyo, Japan Code No. C99200311 G Printed in China...

This manual is also suitable for:

Wh 10dfl

Table of Contents