3 OPERATION
IS Operation Switch
Using the accessories with IS operation
switch function
When using an accessory with IS operation function, refer to
the operating instructions of the accessory.
* (NOTE)
The IS function activated by pressing, releasing or holding down the
button varies according to the lens setting.
Setting the IS operation switch mode
(For models without a display)
<Selecting ALT/MON>
The IS function state alternates between "IS SW-ON"
ALT
and "IS SW-OFF" each time the IS operation switch
is pressed.
The IS function state is momentarily set to "IS SW-
MON
ON" while the IS operation switch is held down.
ALT/MON selection.......... ALT : Set No.7 to OFF.
MON : Set No.7 to ON.
(At the factory, No.7 was set to the OFF position.)
<Selecting SW*/ OFF>
Select the IS operation mode (OFF: IS STD.) when IS
operation switch is OFF.
When SW* is selected:
When the IS operation switch is ON, the IS function operates at the
characteristics preset at the IS selector switches (it stops when OFF
is selected). When the IS operation switch is OFF, the IS function
operates at the standard characteristics (STD).
When OFF is selected:
When the IS operation switch is ON, the IS function operates at the
characteristics preset at the IS selector switches (it stops when OFF is
selected). (The function operates for both the H and V directions.)
When the IS operation switch is OFF, the IS function stops.
SW * / OFF selection....... SW * : Set No.6 to OFF.
SW OFF : Set No.6 to ON.
(At the factory, No.6 was set to the ON position.)
IRIS AUTO
L. CODE
GAIN
TALLY
BRIGHT SW2
SW1
IE MANU.
ON
ANALOG AMP
DIP Switch 1
I. LOCAL
ON
No.1 to No.8
SW
/OFF
/ON
ALT/MON
/ON
POWER OFF
ON
IS MODEL ONLY
TALLY/IND.
ON
OFF
ON/OFF
DIGITAL AMP
SW4
CAFS OFF
ON
"ALT" is set by default.
SW*/OFF
-/ON
ALT/MON
-/ON
POWER OFF ON
IS MODEL ONLY
* (NOTE)
DIP switch 1 No. 8 is the IS main power switch. Normally, the switch
is kept at the OFF position.
(For models with a display)
Change the setting on the information display.
For details on the information display, refer to the "Display
Operation Manual" at the end of this Operation Manual.
Information Display
Setting the Image Stabilizing
Direction and Characteristics
IS Horizontal
Direction Selector
Switch
IS Vertical
Direction Selector
Switch
To select one of the following modes, operate the IS
horizontal (or vertical) direction selector switch.
Standard characteristics
(STD.)
Maximum
characteristics (HIGH)
Stop (OFF)
E16
This mode minimizes unnatural movements
by implementing special processing for
the low-frequency shaking caused by slow
camera work and allows smooth operation
during regular camera operation.
This item is set to ensure that the shaking
in all the frequency bands is stabilized
at the maximum characteristics. If low-
frequency shaking is a concern with
stationary shots, the anti-vibration effect
is enhanced by selecting the maximum
characteristics.
This stops the IS function.