Setting On The Information Display - Canon XJ100x9.3B AF Operation Manual

2-6 Setting on the Information Display

The table below shows the functions that can be set from the information display. For the detailed setting method, refer to
the "Display Operation Manual" at the end of this Operation Manual.
Lens name Lens code setting
Initialize operation Initialize operation setting
Iris gain
Iris control
Setting the iris correction to ON/OFF
Setting the iris close detection to ON/OFF
Setting the zoom servo start characteristics
Setting the zoom servo stop characteristics
Setting the zoom mechanism end stop characteristics
Zoom control Preset
Setting the analog demand curve characteristics
CAM mode settings
Setting the servo mode type from the zoom demand
Focus control Focus demand curve characteristics
Setting the tally lamp ON/OFF
Tally
Tally lamp light quantity setting
Indicator Setting the indicator ON/OFF
CAFS Setting the CAFS ON/OFF
IS mechanical lock setting
IS IS operation switch setting
IS mode setting
Encoder output setting
Other Setting the camera serial communication to ON/OFF
Adjusting the Camera Fol Voltage
Reset operation Reset to default values
Functions that can be set from the information display
Setting the auto iris gain
Setting the remote iris gain
Setting the zoom servo start characteristics
Setting the zoom servo stop characteristics
E11
2 PREPARATION
Reference
page in
appendixes
E4
E4
E4, E5
E5
E5
E6
E6
E6
E6
E7
E7
E7
E8
E8
E9
E6
E11
E8
E9
E10
E10
E10
E11
E11
E12
E1