Bowl Cutter Attachment; Vegetable Preparation Attachment; Blade; Maintenance - Robot Coupe R 401 Instruction Manual

• BOWL CUTTER ATTACHMENT

After removing the lid, remove the bowl from
the motor base by rotating it to the left. Pull up to
disengage, leaving the blade in the bowl in order to
prevent any spillage when working with liquids.
If the food has a solid consistency, remove the blade
and empty the bowl.
Replace the bowl, place the blade back on the shaft
and switch on the machine in order to remove any
mixture which may have stuck to the blade.
If you wish, you can rinse the bowl by filling it with
hot water and switching on for a few minutes.

• VEGETABLE PREPARATION ATTACHMENT

Remove each of the parts, i.e.: the lid, disc, sling
plate and bowl and clean.
Diswashers are best avoided. Instead we recommend
that you clean the machine by hand, using
washing-up liquid.

• BLADE

After cleaning the blade, always dry the blades well
to prevent rusting.
I M P O R T A N T
Check that your detergent is suitable for cleaning
plastic parts. Some washing agents are too alka-
line (e.g. high levels of caustic soda or ammonia)
and totally incompatible with certain types of
plastic, causing them to deteriorate rapidly.
• BLADE
We strongly recommend that the blades (smooth
ones) are sharpened daily using sharpening stone
supplied with machine.
20
The quality of the cut depends mainly on the sharp-
ness of your blades and the degree of wear. The
blades are actually wearing parts, which should be
replaced occasionally to ensure consistent quality in
the final product.

• MOTOR SEAL

The motor seal on the shaft should be lubricated re-
gularly using a food safe lubricant.
In order to keep the motor completely watertight, it
is advisable to check the motor seal regularly for
wear and tear and replace if necessary.
The motor seal can be easily replaced without ha-
ving to remove the motor, so we strongly advise you
to ensure that is in good condition.

• BOWL LOCATING PLATES

If these plates wear out, the bowl will no longer be
securely attached to the motor base.
This makes it awkward to use since the bowl can
come loose during processing.
There is no risk to the user however, because the
safety system will automatically stop the machine.
It is advisable therefore to change these plates in
order to ensure maximum ease of use.

MAINTENANCE

• WEIGHT

R 401 (without disc)
R 402 (without disc)
R 402 V.V. (without disc)
• DIMENSIONS (in mm)
F

• WORKING HEIGHT

We recommend that you position the food processor
on a stable worktop so that the upper edge of the
large feed hopper is at a height of between 1.20 m
and 1.30 m.

• NOISE LEVEL

The equivalent continuous sound level when the
food processor is operating on no-load is less than
70 dB(A).

• ELECTRICAL DATA

TECHNICAL
R 401 single-phase machine
SPECIFICATIONS
net weight gross weight
230 V/50 Hz
13 kg 16 kg
115 V/60 Hz
15 kg 18 kg
220 V/60 Hz
15 kg 18 kg
E
H
D
A
A B
I
C
D
E
B F
J
G
C
H
I
J
Speed Power
Motor
(Rpm) (Watts)
1500 700
1800 700
1800 700
G
R 402
R 401
R 402 V.V.
204 A 224
304 B 304
226 C 226
570 D 590
320 E 320
725 F 745
530 G 530
440 H 440
190 I 190
235 J 235
Intensity
(Amp.)
5,7
12,0
5,7