Table of Contents
Advertisement
P/N 126904-01 Rev.A 02/2014
P126904-01
INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference.
This appliance may be installed in an aftermarket permanently located, manufactured (mobile) home, where not
prohibited by local codes. This appliance is only for use with the type of gas indicated on the rating plate. This
appliance is not convertible for use with other gases.
WARNING: This appliance is for installation only in
a solid-fuel burning masonry or UL127 factory-built
fireplace, constructed of noncombustible material
and connected to a working flue. (See page 6 for
minimum flue opening.)
WARNING: If the information in these instructions is not followed exactly, a fire or explosion may result
causing property damage, personal injury or loss of life.
— Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other
appliance.
— WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire department.
— Installation and service must be performed by a qualified installer, service agency or the gas supplier.
Installation and Operation Instructions
Superior™ Vented Decorative Natural Gas Logs
PFS
Models
®
FVSR18
US
WARNING: This is a gas-fired appliance. It uses air
(oxygen) from the room in which it is installed. Provi-
sions for adequate combustion and ventilation air must
be provided. Refer to the National Fual Gas Codes,
ANSI Z233.1/NFPA 54, Section 5.3 for Combustion
and Ventilation.
FVSR24
FVDR18
FVDR24
FVDR30
Advertisement
Table of Contents
Related Manuals for Superior Gas Log
Summary of Contents for Superior Gas Log
- Page 1 Installation and Operation Instructions Superior™ Vented Decorative Natural Gas Logs P/N 126904-01 Rev.A 02/2014 Models ® FVSR18 FVSR24 FVDR18 FVDR24 FVDR30 P126904-01 INSTALLER: Leave this manual with the appliance. CONSUMER: Retain this manual for future reference. This appliance may be installed in an aftermarket permanently located, manufactured (mobile) home, where not prohibited by local codes.
-
Page 2: Table Of Contents
TABLE OF CONTENTS Safety ..............2 Troubleshooting ..........16 Local Codes............4 Service Hints ............. 19 Unpacking............4 Technical Service..........19 Product Identification ........... 5 Replacement Parts ..........19 Optional Product Features........5 Parts ..............20 Installation ............5 Accessories ............24 Operation ............ - Page 3 SAFETY Continued Natural gas is odorless. An odor- Natural Gas: Appliance assembly becomes making agent is added to the gas. The odor very hot when in use. Keep chil- helps you detect a gas leak. However, the odor added to the gas can fade. Gas may be dren and adults away from hot present even though no odor exists.
-
Page 4: Local Codes
6. The installation and provisions for combus- tion and ventilation air must conform with the 13. This vented gas log set may not be National Fuel Gas Code, ANSI Z233.1/NFPA installed in a bedroom or bathroom in the Commonwealth of Massachusetts 54, Air for Combustion and Ventilation. -
Page 5: Product Identification
PRODUCT IDENTIFICATION Grate Grate Steps Left Hearth Kit Model ___________________ Side Serial Number _____________________ Log Set Model _____________________ Burner Right Side Burner Clamp Burner Inlet Front Burner Manifold Fitting Figure 1 - Product Identification (Dual Burner Shown) OPTIONAL PRODUCT FEATURES ON/OFF SAFETY VALVE/PILOT KIT or other sources to light. - Page 6 The charts in Figure 2, indicate technical this type of gas appliance. Only information regarding the installation of your factory authorized components gas log set. Please make sure that all of the specifications shown are applicable before listed in these instructions may installation is attempted.
-
Page 7: Local Codes
Inter- For Massachusetts Residents Only nally-tinned copper tubing may Installation of this vented gas log set in the be used in certain areas. Check Commonwealth of Massachusetts requires your local codes. Use pipe of the damper be permanently removed or 1/2"... - Page 8 INSTALLATION Continued We recommend that you install a sediment PRESSURE TESTING GAS SUPPLY trap (not supplied with log set) in supply line PIPING SYSTEM as shown in Figure 4. Locate sediment trap Test Pressures In Excess Of 1/2 PSIG where it is within reach for cleaning. Install in (3.5 kPa) piping system between fuel supply and ap- 1.
- Page 9 INSTALLATION Continued HEARTH KIT ASSEMBLY AND SINGLE-BURNER INSTALLATION Burner Manifold Kit Assembly - Single and Dual Flame Only 1. Determine which side gas line will be coming into fireplace. Burner Inlet 2. Using a hammer and screw driver, remove Fitting knockout plug from side of pan that cor- responds to gas line (see Figure 6).
- Page 10 INSTALLATION Continued Installation and Gas Connection 2. Attach pilot gas line to pilot outlet of gas 1. Place burner pan assembly in center of control valve and tighten. Connect ther- fireplace floor. Make sure front of pan mocouple to rear of gas control valve. faces forward.
- Page 11 INSTALLATION Continued 6. Install gas connector tube to gas supply PROPANE/LP GAS CONVERSION fitting. Carefully shape tube to attach to To convert to propane/LP gas, burner inlet adapter fitting. Be careful not to cause fitting and pilot orifice must be replaced. kinks in tube.
- Page 12 INSTALLATION Continued Changing Pilot Orifice Note: Burner design includes more ports The pilot is provided with a natural gas ori- on the outside of the bar. Make sure that fice installed. For propane/LP gas you must all ports are clear and producing flame remove it and replace it with an propane/LP evenly across burner.
- Page 13 INSTALLATION Continued 5. Place smaller top logs onto bottom logs (see Figure 17). Leave as much open space between logs as possible to mini- mize flame impingement and sooting. Note: Logs may chip if they are handled roughly or if hit together while being placed.
-
Page 14: Operation
OPERATION FOR YOUR SAFETY GAS SHUTOFF READ BEFORE LIGHTING VALVE OPERATION Flame Adjustment WARNING: Keep flue open Adjust the flame ON/OFF by turning gas shut- when operating unit. off valve counterclockwise to open or clockwise to close, as necessary. WARNING: If you do not fol- Shutting Off Appliance low these instructions exactly, Turn gas shutoff valve clockwise... -
Page 15: Cleaning And Maintenance
OPERATION Continued Note: You may be running this log set Control Knob Pilot for the first time after hooking up to gas Ignitor supply. If so, the control knob may need to be pressed in for 30 seconds. This will FROM "PILOT"... -
Page 16: Troubleshooting
(Note: It is natural and unavoid- 2. Fireplace venting system 2. Adjust damper wide open able for vented gas log sets not drafting properly and/or have fireplace and to produce moderate levels v e n t i n g p r o f e s s i o n a l l y... - Page 17 TROUBLESHOOTING Continued OBSERVED PROBLEM POSSIBLE CAUSE REMEDY When ignitor button is pressed, 1. Gas supply turned off or 1. Turn on gas supply or open there is spark at pilot but no equipment shutoff valve equipment shutoff valve ignition (GA9050A-1 Only) closed 2.
- Page 18 TROUBLESHOOTING Continued WARNING: If you smell gas • Shut off gas supply. • Do not try to light any appliance. • Do not touch any electrical switch; do not use any phone in your building. • Immediately call your gas supplier from a neighbor’s phone. Fol- low the gas supplier’s instructions.
-
Page 19: Service Hints
SERVICE HINTS TECHNICAL SERVICE You may have further questions about instal- When Gas Pressure is Too Low lation, operation, or troubleshooting. If so, • pilot will not stay lit contact INNOVATIVE HEARTH PRODUCTS • burners will have delayed ignition at 1-800-655-2008. When calling please •... -
Page 20: Parts
PARTS BURNER MODELS FVSR18, FVSR24, FVDR18, FVDR24, AND FVDR30 This list contains replaceable parts used in your log set. When ordering parts, follow the instructions listed under Replacement Parts on page 19 of this manual. NO. FVSR18 FVSR24 FVDR18 FVDR24 FVDR30 DESCRIPTION 14325... - Page 21 PARTS LOG SET MODELS VSLR18, VSLR24, VDLCR18, VDLCR24 AND VDLCR30 This list contains replaceable parts used in your log set. When ordering parts, follow the instructions listed under Replacement Parts on page 19 of this manual. Kingston Split Oak Logs Hanover Round Oak Logs PART NO.
- Page 22 PARTS LOG SET MODELS FSLR18, FSLR24, FDLCR18, FDLCR24 AND FDLCR30 This list contains replaceable parts used in your log set. When ordering parts, follow the instructions listed under Replacement Parts on page 19 of this manual. Manchester Split Oak Logs Arlington Round Oak Logs PART NO.
- Page 23 PARTS LOG SET MODELS FA18, FA24 AND FA30 This list contains replaceable parts used in your log set. When ordering parts, follow the instructions listed under Replacement Parts on page 19 of this manual. Appalachian Oak Logs NO. PART NO. DESCRIPTION QTY.
-
Page 24: Accessories
For all models. Use for additional decoration WALL-MOUNT ON/OFF SWITCH only. (3 pine cones per box.) GWMS2 For all models. Allows the gas log set to be turned on and off with a wall switch. Valve/ Pilot Kit GA9150A must be purchased to use this remote. -
Page 25: Warranty
THE WARRANTY Innovative Hearth Products Limited Three Year Warranty ("IHP") warrants your Superior™ brand Gas Log Set ("Product") to be free from defects in materials and workmanship at the time of manufacture. The logs and grate carry the Limited Three Year Warranty. After installation, if covered components manufactured by IHP are found to be defec- tive in materials or workmanship during the Limited Three Year Warranty period and while the Product remains at the site of the original installation, IHP will, at its option, repair or replace the covered components. - Page 26 WARRANTY KEEP THIS WARRANTY Model (located on product or identification tag) _____________________________ Serial No. (located on product or identification tag) __________________________ Date Purchased __________________________ Keep receipt for warranty verification.
- Page 27 NOTES _____________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ _____________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ _____________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________ ______________________________________________________...
- Page 28 1508 Elm Hill Pike, Suite 108 Nashville, TN 37210 126904-01 1-800-655-2008 Rev. A www.IHP.US.com 02/14 P126904-01...