Announcements Via The Dj Microphone; Prefader Listening To The Channels; Level Adjustment Of A Further Mixer - Omnitronic PM-3010 User Manual

6.4 Announcements via the DJ microphone

1 To switch on the DJ microphone at the jack DJ MIC press the button ON AIR (control LED lights red).
2 Adjust the volume of the microphone announcement with the control LEVEL.
3 Adjust the desired sound with the 3-band equalizer. By adjusting the tone controls, the high frequencies
(control TREBLE), the middle frequencies (control MIDDLE) and the low frequencies (control BASS) can
be boosted or attenuated (± 12 dB).
4 To improve the audibility of an announcement during the current music program, press the button
TALKOVER (control LED lights blue) to activate the talkover function. Then during a microphone
announcement, the levels of channels 1-3 are automatically attenuated by 15 dB.
5 To switch off the DJ microphone press the button ON AIR again (control LED off).

6.5 Prefader listening to the channels

The cue function allows monitoring each of the channels 1-3 via headphones even if the corresponding
channel is faded out. Thus, it is possible, e. g. to time the moment for fading in an audio source. Alternatively
it is possible to monitor the current music program ahead of the master control or the output controls ZONE
and BOOTH.
1 For prefader listening to a channel, press the corresponding switch CUE (control indicator lights) and
turn the control CUE MIXING to the left stop position "CUE". To monitor the current music program
ahead of the master control and the output controls ZONE and BOOTH, turn the control CUE MIXING to
the right stop position "MASTER".
2 Select the monitoring mode with the selector switch CUE MODE:
• SPLIT (button pressed, red LED lights): The prefader level (mono) is on one side and the output signal
(mono) is on the other side of the headphones.
• MIX (button released, blue LED lights): A mixed signal of prefader level and master signal is on both
sides of the headphones.
3 Adjust the desired headphones volume with the control CUE LEVEL.

6.6 Level adjustment of a further mixer

When a further mixer is connected to the jacks SESSION, the input level can be adjusted with the control
SESSION IN. Please note that the signal is directly routed to the mix and not to the crossfader.
28/31 00043092.DOC, Version 2.0