Installation - Omnitronic PM-3010 User Manual

5 INSTALLATION

The PM-3010 can be used as a table top unit or it can be installed into a console. Please make sure that
there is enough space around the unit for ventilation to improve heat dissipation. Steady overheating will
damage the unit.
Switch off the mixer prior to connecting any units or to changing any existing connections.
1 Connect the stereo audio sources to the corresponding RCA jacks (white jack = left; red jack = right):
• The jacks MAIN INPUTS CH-1 to CH3 are assigned to the channels 1-3 and allow for connecting units
with line level output e.g. CD players or turntables. If your turntable is equipped with a separate ground
lead, connect it to the corresponding clamping screw GND.
• The jacks AUX 1 to 4 can be freely assigned to each channel and allow for connecting units with line
level output e.g. CD players or tape decks.
• Aux and mic input sources are freely assignable to each channel. For creative mixing, the same source
may be assigned to several channels.
2 You can connect three microphones: a DJ microphone to the DJ microphone channel DJ MIC and two
further microphones to the microphone channels MIC 1 and MIC 2.
• Connect a DJ microphone via an XLR plug or a 6.3 mm plug to the front input DJ MIC
• Two further microphones can be connected via 6.3 mm plugs to the rear inputs MIC 1 and MIC 2 and
can be freely assigned to each channel.
25/31 00043092.DOC, Version 2.0