Nikon HVBTR-1200 Instructions For Use Manual page 9

5. Z-axis motion prat
Do not let the optical head or the LEDs collide with the workpiece or the clamps. If there is a
collision, press the STOP switch, turn off the power, and then remove the cause of the collision.
After restarting the system, even if it appears that everything is operating normally, be sure to
"calibrate the optical head" and "check the Laser Autofocus focal position offset". We also
recommend that you have your nearest Nikon representative to inspect the system.
6. USB and IEEE1394 setting
Do not connect the supplied USB cable and IEEE1394 cable before the iNEXIV software is
installed. If the cable is connected before the installation of the software, the device driver may not
be set correctly.
The iNEXIV software can be used only when the appropriate driver is detected and installed when
the cable is connected for the first time according to the instructions provided during the software
installation.
7. Cleaning finished surfaces and plastic components
We recommend using a silicone cloth to clean finished surfaces and plastic components. If a
surface is especially dirty, wipe it with a dilute, mild detergent. Do not use solvents (such as paint
thinner, alcohol, or ether).
8. Isolation from the power supply
The weak electric power is running through the system even when its power switch is turned off.
In the following conditions, be sure to unplug the power cord from the power outlet.
• When the system is not used for a long period of time.
• When you wish to isolate the system from the power source.
• In case of malfunction.
- vii -