Kohler COMMAND CH18-745 Service Manual page 116

4. Place the brake washer in the recess in starter
pulley; over the center shaft.
5. Lubricate the brake spring sparingly with grease.
Place the spring on the plain washer. Make sure
the threads in the center shaft remain clean, dry,
and free of grease and oil.
6. Apply a small amount of Loctite
threads of the center screw. Install the center
screw, with the washer and retainer, to the center
shaft. Torque the screw to 7.4-8.5 N·m
(65-75 in. lb.).
7. Tension the spring and install the rope and handle
8. Install the starter to the engine blower housing as
® No. 271 to the
Retractable Starter
as instructed in steps 6 through 12 under "Rope
Replacement" on page 7.2.
instructed in "To Install Starter" on page 7.1.
Section 7
7
7.5