Antelope 2 PURE Owner's Manual page 9

from: 32kHz, 44.1kHz, 48kHz, 88.2kHz, 96kHz, 176.4kHz, 192kHz. The current
frequency is indicated on the display (6) when adjusting.
Press and hold the 'frequency up' button to see the routing table and press and hold to
return to the main display view.
6. Display
Multi-function display that shows Sample Rate on the left and volume levels for the
inputs on the right. It displays independently assignable sources that are adjustable from
the software control panel.
Note: Be aware that there might be a protective film over the display, which dims the
illumination – feel free to remove it.
7. Rotary control
This large stepped attenuator has the ability to adjust levels for analog outputs (19) and
headphone output (10). The level is shown on the display (6) when adjusting, with a
range of -95dB to 0dB with 0.05dB steps. By clicking the Rotary control you can mute
the currently selected output.
Press the Rotary control to enter the sub-menu and rotate to navigate through the
available options.
8. Volume Select button
This allows you to select if the Rotary control is adjusting the monitor outputs or the
headphone outputs.
Press and hold for 2 seconds, to enter the device control menu. This button also acts as
a cancel selection button when navigating the sub-menus of the device.
9. Preset buttons
Three Preset buttons store and recall your 'favorite' set-ups. Save your presets by
clicking and holding for 2 seconds. This can also be done via the software control panel
by holding the Command key for Mac / Control key for Windows while clicking on the
preset.
10. Headphone Output
A ¼" TRS Stereo Headphone jack for connecting headphones for a wide range of
impedances
10