Front Panel Explained - Antelope 2 PURE Owner's Manual

5. Front Panel Explained

1. Power button
Toggles standby/operation state
When you press & hold the power button the following 'Options' menu is displayed:
- Device Info
- Brightness
- Input Trim
- Output Trim
- Reset
- Screen Saver
- 10M Calibration
2. Oven Clock light
When lit, this indicates Pure2 is clocked by it's own internal clock.
3. Lock light
When lit, this indicates Pure2 is locked to an incoming digital signal via rear panel
connectors including Word Clock, AES, S/PDIF Toslink (14) and USB playback. The light
will flash if there is no valid digital signal.
When your device is in Oven mode and you play a track via USB, the clock is slaved to
USB and the display shows: "Clock: USB". The Oven Clock light (2) is lit and the Lock
light remains off.
4. Atomic Clock light
When lit, this indicates Pure2 is locked to an atomic signal that enters through the 10M
input on the rear panel. When an active atomic signal is present, the Oven Clock light
switches off and the Atomic Clock light switches on. This only occurs in Oven Mode. If a
digital input is selected for sync source the Lock light switches on if there is a valid signal
present in the input or blinks when the signal is missing.
5. Frequency buttons
These two arrow buttons allow you to increase and decrease the sample rate, selecting
9