Nest Time - Kodak Printe Reference Manual

TM
VinylJet 36 Reference Guide
The following parameters will not affect nesting:
To enable nesting
1 F r o m t h e mai n menu, choose
2 Press Select.
3 Use the up or down arrow button to display Nest On or Off.
4 Press Select.

Nest time

Nest time is the amount of time the printer waits for the next plot to fill the
current nest.
The printer will begin printing whenever the printer has been idle for the speci-
fied time interval. The time is reset whenever a print job is received.
To define nesting wait time
1 From the main menu, choose Setup Menu/HP-GL/2 Options/Nest Time.
2 Press Select.
3 Use the up or down arrow button to display the desired nest time.
4 Press Select.
4-6 HP-GL/2
• Ink limiting;
• Replots;
• If Auto Rotation is enabled, then the nesting algorithm is free to rotate
the plot if it determines that doing so will save media. Plots are sequen-
tially fitted across the page from right to left; and
• The HP-GL/2 EC command can be used to control cutting. If any plot in
a nest has the cutter enabled, the plotter will cut after the nest.
Setup Menu/HP-GL/2 Options/Nest Enable.