Practical advice on using the burners Practical advice on using the electric hotplates Precautions and tips, 8 General safety Disposal CISPF 640 E IX/HA 7HPF 640 S RU/HA Maintenance and care, 9 7HPF 640 E IX RU/HA Switching the appliance off...
Installation ! Before operating your new appliance please read this also be equipped with vents to allow gas to escape in the instruction booklet carefully. It contains important information event of a leak. As a result LPG cylinders, whether for safe use, installation and care of the appliance. partially or completely full, must not be installed or stored in rooms or storage areas that are below ground level ! Please keep these operating instructions for future...
Front Connecting the supply cable to the mains Install a standardised plug corresponding to the load indicated on the data plate. The appliance must be directly connected to the mains using an omnipolar circuit-breaker with a minimum contact opening of 3 mm installed between the appliance and the mains. The circuit-breaker must be suitable for the charge indicated and must comply with current electrical regulations (the earthing wire must not be interrupted by the circuit-breaker).
There is an adjustable L L L L L -shaped pipe fitting on the to the low flame setting, increase this low flame setting appliance supply ramp and this is fitted with a seal in using the adjusting screw. order to prevent leaks. The seal must always be replaced after rotating the pipe fitting (seal provided with appliance).
P.C.S. = 50.37 MJ/kg. Butane P.C.S. = 49.47 MJ/kg. Natural P.C.S. = 37.78 MJ/m CISPF 640 E IX/HA 7HPF 640 S RU/HA 7HPF 640 E IX RU/HA 7HPF 640 E RU/HA 7HPF 640 ES IX RU/HA 7HPF 640 ES RU/HA...
Description of the appliance Overall view GAS BURNERS Support Grid for COOKWARE Control Knobs for GAS BURNERS Ignition Button for GAS BURNERS * SAFETY DEVICES * Ignition for GAS BURNERS * • GAS BURNERS differ in size and power. Use the diameter of the cookware to choose the most appropriate burner to cook with.
Start-up and use Practical advice on using the burners ! The position of the corresponding gas burner or electric hotplate* is shown on every knob. To ensure the burners operate efficiently: • Use appropriate cookware for each burner (see Gas burners table) so that the flames do not extend beyond Each burner can be adjusted to one of the following the bottom of the cookware.
Precautions and tips ! This appliance has been designed and • Do not close the glass cover (if present) when the manufactured in compliance with international safety gas burners or electric hotplates are still hot. standards. The following warnings are provided for •...
Maintenance and care Switching the appliance off Gas tap maintenance Disconnect your appliance from the electricity Over time, the taps may become jammed or difficult supply before carrying out any work on it. to turn. If this happens, the tap must be replaced. ! This procedure must be performed by a Cleaning the appliance qualified technician authorised by the...
Troubleshooting It may happen that the appliance does not function properly or at all. Before calling the service centre for assistance, check if anything can be done. First, check to see that there are no interruptions in the gas and electrical supplies, and, in particular, that the gas valves for the mains are open.
Need help?
Do you have a question about the CISPF 640 E IX/HA and is the answer not in the manual?
Questions and answers