Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Bosch LTC 7950 Series
Summary of Contents for Bosch LTC 7950 Series
- Page 1 LTC 7950, LTC 7960 Series Instruction Manual EN Pressurized Environmental Cameras...
-
Page 2: Important Safeguards
9. Safety Check - Upon completion of servicing or repairs to the unit, ask the service technician to perform safety checks to ensure proper operating condition. Bosch Security Systems | January 03, 2005... -
Page 3: Safety Precautions
2. Mechanical Loading - Mounting of the equipment in a rack shall be such that a hazardous condition is not achieved due to uneven mechanical loading. Bosch Security Systems | January 03, 2005... -
Page 4: Fcc Information
Toutefois, las unidades. l'appareil ne fonctionne réellement que lorsque le commutateur est réglé sur ON. Le débranchement du cordon d'alimentation permet de couper l'alimentation des appareils. Bosch Security Systems | January 03, 2005... - Page 5 L'unità è tuttavia in funzione solo quando l'interruttore ON-OFF si trova nella posizione ON. Il cavo di alimentazione costituisce il dispositivo di scollegamento dell'alimentazione principale per tutte le unità. Bosch Security Systems | January 03, 2005...
-
Page 6: Table Of Contents
SPECIFICATIONS .............14 Bosch Security Systems | January 03, 2005... -
Page 7: Unpacking
Verify that all parts shown in the Parts List have been 3.3 Environmental Enclosure included. If any items are missing, notify your Bosch Security Systems Sales or Customer Service Representative. 3.3.1 Construction These cameras are self-contained (within one case), with a... -
Page 8: Installation
The phase lock loop circuit controlling the sync Sunshield Lens generator synchronizes the camera to the power line TC1366-21 Fixed & 10X zoom models zero crossing. This feature improves vertical interval TC1366 20X zoom models Bosch Security Systems | January 03, 2005... -
Page 9: Electrical
Figure 6: Depressurizing ring on the front of the housing (see Figure 10). Remove the retaining ring on the rear of the housing (see Figure 6). Bosch Security Systems | January 03, 2005... -
Page 10: Closing The Housing
Replace the retaining ring on the rear of the housing (see Figure 6). WARNING: The pressure in the housing must never exceed 140 kPa (20 PSIG). Reinsert and tighten the rear Vent Screw (see Figure 9) . Bosch Security Systems | January 03, 2005... - Page 11 Inspect for leaks around the end seals, Fill Valve, Over Pressure Safety Valve, Vent Screws, and the 30-pin connector (see Figure 11) . If any leaks are found, reseal, repeat the purge, and check again. Bosch Security Systems | January 03, 2005...
-
Page 12: Connector Pinouts
Power Receptacle Alarm In ground Dinion XF & D/N Alarm In Dinion XF & D/N Alarm Out relay Contact No.1 Dinion XF & D/N Alarm Out relay Contact No.2 Dinion XF & D/N Bosch Security Systems | January 03, 2005... -
Page 13: Vac 60 Hz Cameras
Power Receptacle Alarm In ground Dinion XF & D/N Alarm In Dinion XF & D/N Alarm Out relay Contact No.1 Dinion XF & D/N Alarm Out relay Contact No.2 Dinion XF & D/N Bosch Security Systems | January 03, 2005... -
Page 14: Specifications
EN | 14 LTC 7950, 7960 Series | Instruction Manual | Specifications SPECIFICATIONS For current specifications, please refer to the Data Sheet on the Bosch website: www.boschsecurity.com. Data is subject to change without notice. Bosch Security Systems | January 03, 2005... - Page 15 EN | 15 LTC 7950, 7960 Series | Instruction Manual | Bosch Security Systems | January 03, 2005...
- Page 16 Bosch Security Systems, Inc. Bosch Security Systems B.V. Bosch Security Systems Pte Ltd. 850 Greenfield Road P.O. Box 80002 38C Jalan Pemimpin Lancaster, PA 17601 USA 5600 JB Eindhoven Singapore 577180 Tel: 800-326-3270 The Netherlands Republic of Singapore Fax: 1-717-735-6560...
Need help?
Do you have a question about the LTC 7950 Series and is the answer not in the manual?
Questions and answers