Corrective Maintenance - Pride Mobility LUXOR Owner's Manual

V I I .
WARNING! Make sure you tighten the fasteners so
that the connections are secure.
13. Place the lid back onto each battery box.
14. Refasten the straps on each battery box.
15. Slide the batteries back into the power base.
16. Reconnect the battery boxes.
17. Reconnect the controller. Make sure that the "A" on the front battery
box faces the front of the power chair and the "B" on the rear
battery box faces the rear of the power chair. The main circuit
breaker on the rear battery box should be on the left side.
18. Charge the batteries. See VI. "Batteries and Charging."
When to See Your Authorized Pride Provider for
Service
The following symptoms could indicate a serious problem with your
power chair. If necessary, contact your authorized Pride Provider.
When calling, have the model number, serial number, nature of the
problem, and the error code if available.
Motor noise
Frayed harnesses
Cracked or broken connectors
Uneven wear on any of the tyres
Jerky motion
Pulling to one side
Bent or broken wheel assemblies
Does not power up
Powers up, but does not move

Corrective Maintenance

If the battery condition meter does not light up when you turn on the
power:
Check the harness connections. Make sure they are tight.
Check the circuit breaker. Reset it if necessary.
Check the battery connections.
If the above conditions prove normal, you can load test the batteries
with a battery load tester. These testers are available at automotive
parts stores. Disconnect both batteries before load testing and follow
the directions that come with the load tester. If either one of the bat-
teries fails the load test, replace both of them. If your power chair still
does not power up, contact your authorized Pride Provider.
Luxor
C A R E A N D
www.pridemobility.com
M A I N T E N A N C E
Figure 31. Battery Wiring Diagram
35