Rear Panel Overview; The Dip Switch Features - Lab.gruppen C 68:4 Operation Manual

6. Rear Panel overview

200-240VAC 50-60Hz :2300W
Must be grounded
Made in Sweden
Mains input 115V or
230V operation
(Not selectable)
.
44dB
141V* 71V
41dB
38dB 118V 59V
50V
35dB 100V**
PUSH PUSH
32dB 85V 42V
29dB
26dB
23dB
*100V rms **70V rms
NomadLink DIP switches
network In and Out for adjusting key
on EtherCon housed features
RJ45 connections (See below)
QUICK GUIDE OVERVIEW 6
Ser. N:o
Removed!
BALANCED INPUTS
CH D CH C CH B CH A
3-pole Phoenix
input connectors

6..1 The dIP switch features

The following features may be adjusted using the
DIP switches on the rear-panel of the amplifier.
Gain - Set for all four channels from +23 dB to +44
dB in 3 dB steps.
Option active - Available for future upgrades.
fan Masked - When on, engages the intelligent
fan feature lowers fan speed when no signal is
present.
Bridged A+B and C+d- Switches the channel pairs
into bridged mode operation (automatic -6 dB gain
compensation).
VPL - Voltage Peak Limiter adjustment is
provided for 8 individual levels. Select the setting
most appropriate for connected speakers. See
Appendix for details.
Mode - Select VPL mode between Hard and Soft. For
channels driving sub-woofers and Lo-end frequen-
cies, it is recommended to use the Hard setting for
optimal operation. For mid and hi-end drivers, always
select Soft.
SPEAKER OUTPUTS
WIRING
NORMAL: CLASS 2
BRIDGED: CLASS 3
2-pole screw
terminal output
connections
C Series Operation Manual 11