Table of Contents
Advertisement
User's Manual
2.1.2 Resetting to the Factory Default Baseline
Reset all the camera settings and selections to the original default values as follows:
1. Press the
button to open the menu system.
menu
2. Push the joystick to the right two times to access the Setup menu tab.
3. Push the joystick down thirteen times to highlight Reset Camera.
4. Press the joystick straight down to select the highlighted item.
5. Note the message at the top of the screen:
Reset all camera settings except those in Custom mode.
6. Push the joystick up to highlight Continue (affirming your intent to
complete the action as described in the message).
7. Press the joystick straight down to activate the highlighted choice.
8. Press the
button to exit the menu system.
menu
2.1.3 Entering the AFHCAN Recommended Settings
The following procedures assume that the camera has been reset to factory defaults (refer to
Section 2.1.2 or Figure 11). A complete list of camera menu items and options is shown in
Appendix A.
2.1.3.1 Capture Tab
The following sequence sets two items in the Capture tab to the recommended AFHCAN
settings. These items include:
• Picture Size
• Color Mode
1. Press the
button to open the menu system.
menu
2. Push the joystick down two times to highlight Picture Size.
3. Press the joystick straight down to select the highlighted item.
4. Push the joystick down three times to highlight 6 MP (4:3).
PUB-124 Rev A.doc
Digital Camera
set to 6 MP
set to Low Color
26
Kodak V1233
x 2
x 13
x 2
x 3
Advertisement
Table of Contents
