Fault Code Chart - Jenn-Air JDS8850AAB Service Manual

Troubleshooting Procedures
To avoid risk of electrical shock, personal injury, or death, disconnect power and gas to oven before servicing,
unless testing requires power and/or gas.
Problem
Oven door will not unlock.
Self-clean cycle not working.

Fault Code Chart

Fault Code
F0-0
F1-1
F1-3
F1-5
F1-7
F1-8
F1-9
©2005 Maytag Services
!
W ARNING
Possible Cause
Oven is self-cleaning ...............................
Oven is still hot ........................................
Programming error ..................................
Door lock .................................................
Description
No Fault.................................................. • None.
Oven temperature above 650° F
(343° C) in bake mode ........................... • Ohm sensor and harness (see "Oven
Oven temperature above 950° F
(510° C) during a clean cycle ................. • Ohm sensor and harness (see "Oven
Cancel pad not responding .................... • Ensure ribbon cable is securely
Membrane disconnected........................ • Ensure ribbon cable is securely
Shorted key (pad) in membrane switch . • Ensure ribbon cable is securely
Internal control communication errors.... • Replace control.
16026016
Correction
• Allow cycle to complete.
• Will not unlock until unit has cooled to
safe temperature. Do not force door
open, this will void warranty. Blow
cool air on door latch area to quicken
process.
• Turn off circuit breaker for five
minutes and try oven again.
• Verify door lock energizes & engages.
Component to Troubleshoot/Replace
Sensor" chart). If OK, change
control.
Sensor" chart). If OK, change
control.
connected, inspect ribbon cable and
connector (shorts, breakage,
corrosion, etc.). If OK, replace
control.
connected, inspect ribbon cable and
connector (shorts, breakage,
corrosion, etc.). If OK, replace
control.
connected, inspect ribbon cable and
connector (shorts, breakage,
corrosion, etc.). If OK, replace
control.
13