Winnebago Ultimate Advantage Owner's Manual page 51

NOTE: Check fuses #16-Step Alarm and #24-Ra-
dio/Acc. There is also a fuse on the back
of the HWH leveling system control pad.
Unfasten the control pad from the driver
side armrest panel to inspect the fuse.
If an apparent cause is not found, follow the
crank-in procedure below.
Step 1 - Relieve Hydraulic Line Pressure
· Open the slideout solenoid valves on the
hydraulic pump to relieve hydraulic line pres-
sure. (See Step 1 under "Slideout Room
Emergency Crank-In" on previous pages.)
· DO NOT OPEN THE FOUR T-HANDLED
VALVES ON THE OUTSIDE END OF
THE PUMP. These regulate the coach level-
ing jacks.
Step 2 - Attach Winch and Straps
The crank assembly is generally stored in the
left rear cargo compartment. Assemble the winch
support frame as shown in the illustration using
the large L-shaped steel pin supplied with the
crank.
Move the mattress from the bedroom into the
hallway.
1) Lift the bedboard and unfasten the gas
•
props from the bottom side of the bedboard.
2) Raise the bedboard upward completely
•
against the overhead cabinets. Cover the
edge of the bedboard with a towel to avoid
damage to the cabinets.
3) The winch support frame is mounted to
•
the engine cover near the foot of the bed.
Pull the L-pin from the tube and pivot the
support frame tubes into a triangle position.
Reinsert the pin through the lower frame
tube to lock in place.
DRIVING YOUR MOTOR HOME
4) Fasten the mounting plate of the winch
•
crank onto the mounting plate on the support
frame as shown using the extra bolts in the
frame tube.
• 5) Remove the 3 drawers from the lower left
side of the wardrobe as indicated to provide
access to the bottom mooring bracket attach-
ment point. Open doors shown to provide a
"straight line" access to attachment points.
Do Not route belts around dividers or sup-
ports in a manner that could place pressure
on these items and damage the cabinets.
• 6) Attach the ends of the 2 long, black nylon
straps into the 4 mooring brackets inside the
large cabinets at both ends of the wardrobe.
• 7) Hook center of these straps into hook on
the winch strap.
Insert peg end of strap into hole and slide to lock
SECTION 2
2-29