How To Install; Step 1: Where To Install; Step 2: Installation Choice - SELFSAT H10D User Manual

Horn array type satellite antenna with dual linear polarization

Hide thumbs Also See for H10D:

Table of Contents

Enlarged version

How to Install?

By following the instructions step by step you can proceed easily to install

SELFSAT-H10D by yourself or with the help of a professional antenna installer.

Before installing your antenna, you check that SELFSAT-H10D box contains all the items

listed above in the 'Box Content' . In the event of any missing parts, please contact your

distributor.

In order to receive a signal from the Satellite, SELFSAT-H10D is to be installed in an open

loop space (outside the house or the apartment), in the direction of the satellite towards the

equator, for which, you will need a compass to exactly orient SELFSAT-H10D toward the

satellite (Note; please take reference to the table of the Azimuth angles specified in the

back pages of this manual)

Note; To ensure an accurate compass reading,

stay away from large metal objects, specifically

electrical cables and then make multiple readings

Make sure that there are no obstacles in front of SELFSAT-

H10D which can decrease the signal reception quality, such

as buildings, or trees (you may keep in mind that trees will

grow and may block the signal).

In order to be able to fix and install your antenna easily you

might choose an easily accessible place without any potential danger for installation.

Think about the way you might pass your cable in a discreet way from the SELFSAT-

H10D to your Set top Box. The antenna should not be too distant from your satellite

receiver; a cable longer than 30 meters can decrease the quality of the signal.

Depending on the choice of installation position for the SELFSAT-H10D, you can then

decide on the mounting type, all parts are included .

A) Table Stand type (On a Horizontal Plain)

Table of Contents