Picture quality problems
Status
The picture is too dark or
underexposed
The picture is too light
The picture is not clear
www.kodak.com/go/support
Cause
■
Use Fill flash
(page
behind the subject.
■
Move so that the distance between you and the subject is within
the effective flash range
■
To automatically set exposure and focus, press the Shutter
button halfway and hold. When the ready light glows green,
press the Shutter button the rest of the way down to take
the picture.
■
Decrease the shutter speed or increase the ISO speed
■
Turn flash off
(page
■
Move so that the distance between you and the subject is within
the effective flash range (see
■
To automatically set exposure and focus, press the Shutter
button halfway and hold. When the ready light glows green,
press the Shutter button the rest of the way down to take
the picture.
■
Increase the shutter speed or decrease the ISO speed
■
To automatically set exposure and focus, press the Shutter
button halfway and hold. When the ready light glows green,
press the Shutter button the rest of the way down to take
the picture.
■
Clean the lens
(page
■
Make sure camera is not in Close-up mode if you are more than
27.6 in. (70 cm) from your subject.
■
Place the camera on a flat, steady surface or use a tripod.
16) or change your position so light is not
(page
16).
16).
page
16).
57).
Troubleshooting
(page
14).
(page
14).
50