Specifications; Operation Instructions - APW Wyott AT Express Installation And Operating Instructions Manual

III. Toaster Placement
A. Locate the toaster near a grounded receptacle of the proper configuration (see below). Plug
the cordset directly into receptacle (DO NOT USE AN EXTENSION CORD).
1. In the United States, NEMA 5-15R.
2. In Canada, NEMA 5-20R.
B. Place the toaster on a flat surface providing the following minimum clearances:
1. Base = one inch (provided with legs installed).
2. Side and back walls = two inch
3. Overhead = Enough space to allow adequate heat displacement.
4. WARNING: Failure to provide these clearances will cause unit failure and invalidate
warranty claims.
C. Position toaster where customers will not contact any surface labeled "CAUTION HOT".
NOTE: DO NOT OPERATE THE TOASTER WITH THE LEGS REMOVED.
I. Preparation
A. Clean toaster thoroughly before first use (See cleaning instructions).
B. Controls Familiarity
1. Top Heat Switch: Operates top elements and conveyor.
2. Bottom Heat Switch: Operates bottom element and conveyor.
C. Warm-up time: Allow five (5) minutes.
II. Normal Use
A. Loading Product
1. Place product on Wire Feeder. The conveyor will automatically draw product through the
toaster at a speed determined by conveyor speed control.
B. Toasting Darkness: determined by conveyor speed.
1. Darkest toasting - set conveyor speed control to one (1).
2. Lightest toasting - set conveyor speed control to ten (10).

SPECIFICATIONS

15.634
2.356
14.723
13.271
1.000

OPERATION INSTRUCTIONS

40°
5