Table of Contents
Advertisement
Troubleshooting
Picture quality problems
If...
The picture is too dark
or underexposed
The picture is too light
The picture is not clear
57
Try one or more of the following
■
Use Fill flash
(page
not behind the subject.
■
Move so that the distance between you and the subject is
within the effective flash range
■
To automatically set exposure and focus, press the Shutter
button halfway and hold. When the ready light glows
green, press the Shutter button completely down to take
the picture.
■
Increase Exposure Compensation
■
Turn flash off
(page
■
Move so that the distance between you and the subject is
within the effective flash range (see
■
To automatically set exposure and focus, press the Shutter
button halfway and hold. When the ready light glows
green, press the Shutter button completely down to take
the picture.
■
Decrease Exposure Compensation
again.
■
Check if you are in Beach or Snow scene mode.
■
To automatically set exposure and focus, press the Shutter
button halfway and hold. When the ready light glows
green, gently press the Shutter button completely down to
take the picture.
■
Clean the lens
(page
■
Make sure camera is not in Close-up mode if you are
further than 0.4 in (1 cm) from your subject.
■
Place the camera on a flat, steady surface.
16) or change your position so light is
(page
16).
(page
16).
page
(page
65).
www.kodak.com/go/support
24) and try again.
16).
24) and try
Advertisement
Table of Contents
