Basic Sign Operation; Turning A Sign On And Off - Adaptive Beta-Brite 1024 Programming Manual

Turning a sign on and off

When you plug in the sign's power supply, the sign starts up
automatically, and unplugging the power supply turns the sign off.
However, instead of unplugging a sign, there is another way to turn a
sign off:
Holding down
NOTE: Messages that you have programmed into the sign will not be
lost when you turn a sign off. Messages will be retained for
up to 30 days if the sign is not powered.
When a sign starts up, the following will be displayed:
10404402d EZ95
Basic sign operation: Turning a sign on and off

Basic sign operation

and then pressing
SHIFT
THEN
8K RAM
THEN
WED 1:26 PM
Remote Control Programming Manual
turns a sign off and on.
PROGRAM
This is the software (or "firmware") inside the sign.
This is the amount of memory inside the sign.
Because the time and date are not updated when the
sign is off, the time and date must be re-
programmed each time the sign is turned back on.
(See "Setting a sign's time and date" on page 4.)
3