Table of Contents
Advertisement
Pneumatic Foot Pedal (14A): Press On, release Off
While following these procedures, it may be helpful to refer to the Parts List and Assembly
Drawings located at the end of this manual.
1.
Unplug the Power Cord from the electrical outlet.
2.
Pull up on the Direction Lever (44-16) to place it in the NEUTRAL position.
3.
Loosen Tension Knob (44-13) and pull out three feet of cable from the Drum (38a).
4.
Slide the Guide Spring (48) over the cable and onto the Adapter (44-3) on the end of
the Cable Feed Unit.
5.
Pull out and align the Spring Loaded Pin (46) on the Guide Spring, with the hole in the
Adapter (44-3).
6.
Retighten Tension Knob (44-13).
There are four Cutting Tools included with the Drain Cleaner. Select the appropriate
tool for the cleaning job and attach to Cable (39a). Each is described in the table below.
Cutter Tool
Arrow Cutting Head (59)
Auger Bulb (60)
1-1/2" U-Cutter (61)
1-1/4" Side Cutter Blade (62)
1.
Select the desired cutter tool and insert it into the female connector located at the
end of the Cable (39a). It is recommended to start with the Arrow Cutting Head (59)
or Auger Bulb (60). Once the drainpipe is opened, then use the 1-1/2 U-Cutter (61)
or 1-1/4" Side Cutter Blade (62) to scrape the inside wall of the drain pipe, for a more
SKU 66508
Star Knob
(44-13)
Attaching Guide Spring (48)
Select and Attach Proper Cutting Tool
Starting tool for cutting and scraping
Starting tool to remove loose objects
Finishing tool for grease stoppages and scraping pipe walls
Starting / Finishing tool to remove loose objects and scraping pipe walls
For technical questions, please call 1-800-444-3353
Direction Lever (44-16): Pull Up: forward direction,
Center: neutral; Push down: slow reverse, Fast
reverse direction.
Application
REV 09b
Page 9
Hide quick links:
Advertisement
Table of Contents
