Mazda CX-7 2007 Installation Instructions Manual page 7

5
HOOD SAFETY SWITCH MOUNTING, continued
4. Using fish wire, pull the hood safety switch wiring and tach wire through the main wire harness
grommet:
a. From inside of the vehicle, bend approximately three (3) inches of tach wire at wire end.
b. Using electrical tape, secure fish wire to tach wire as shown. (FIGURE S)
c. Insert the fish wire along with tach wire through the main wire harness grommet into the
engine compartment. (FIGURE T & U)
!
CAUTION: Do not pierce the main wire harness with fish wire when pulling through
main grommet.
d. Disconnect tach wire from fish wire and pull remaining slack of tach wire from the inside
of the vehicle out into the engine compartment.
e. Bend approximately three (3) inches of hood safety switch wiring at wire end.
f. Using electrical tape, secure fish wire to hood safety switch wiring as shown.
(FIGURE S)
g. Pull fish wire and hood safety switch wiring back through main wire harness grommet
into the vehicle. (FIGURE T & U)
h. Disconnect hood safety switch wiring from fish wire and pull remaining slack of hood
safety switch wiring from the engine compartment into the vehicle.
FIGURE S
FIGURE T
FIGURE U
7
4280246 Rev. B 11/10