System Power-Up; Underhood Warning Label Mounting; Tachometer Programming - Mazda CX-7 2007 Installation Instructions Manual

15

SYSTEM POWER-UP

1. Verify that all connections are secure as per installation instructions.
2. Ensure 15 amp Room fuse is properly installed in dash fuse panel.
3. Turn the ignition key to the RUN position.
4. Reconnect the negative battery terminal.
5. Turn the ignition key to the OFF position.
16

UNDERHOOD WARNING LABEL MOUNTING

1. Open the engine hood and find a suitable mounting location in the engine compartment that will be in plain
sight when the hood is open (on the radiator cowl).
2. Using an alcohol pad, clean the mounting surface thoroughly.
3. Remove the backing on the underhood sticker and mount in place.
4. Close engine hood.
17

TACHOMETER PROGRAMMING

1. Tachometer Programming - Make sure engine hood is closed!
a. Turn the ignition key to the ON or RUN position.
b. Press and hold the programming button. After 10 seconds the horn will beep 3 times.
c. Release the programming button.
d. Press and release the programming button a second time.
The horn will beep 4 times, indicating that the system has entered option learn mode.
e. Press and release the brake pedal. The horn will beep 1 time indicating that the system has
entered tachometer learn mode.
f. Start the vehicle with the ignition key and let engine warm up to a normal idle rate. (Less than
1000 RPMs)
The horn will beep 1 time every 3 seconds indicating the system is monitoring the idle rate.
g. Once the vehicle's engine has warmed up, press and release the programming button.
The horn will beep 4 times, indicating that the system has learned the current idle rate.
h. Turn the ignition key to the OFF position.
17
4280246 Rev. B 11/10