Key-In-Sense & Push Wire Routing; Key-In-Sense Connection; Vehicle’s Key-In Sense Wire - Mazda CX-7 2007 Installation Instructions Manual

9
WIRE HARNESS CONNECTIONS - STEERING COLUMN, continued
KEY-IN-SENSE & PUSH WIRE ROUTING
1. Route the remote start harness Red/Black and White/Green wires
along with the immobilizer interface ribbon cable between the
vehicle's yellow shielded harness and steering column harness
to protect the wires from any potential damage from the steering
column cover and tilt steering wheel mechanism. (FIGURE GG)
2. Using supplied, short wire ties, secure the remote start harness
wires to the vehicle's harness. (FIGURE GG)
!
CAUTION: FAILURE TO ROUTE THE REMOTE START HAR-
NESS WIRES PROPERLY COULD RESULT IN DAMAGE TO THE
WIRES DURING RE-ASSEMBLY. IF THE RED/BLACK OR WHITE/
GREEN WIRES ARE SHORTED TO GROUND, THE SMART-KEY
SUBSET WILL GET DAMAGED AND NEED TO BE REPLACED.

KEY-IN-SENSE CONNECTION

1. Locate the 12-pin (Smart-Key equipped) or 2-pin (Retractable
Key equipped) WHITE key-in-sense connector under the igni-
tion switch. (FIGURE HH)
2. Using a razor knife carefully cut back 1"-2" of the electrical tape
to expose the wiring. (
FUL NOT TO DAMAGE ANY OF THE WIRES.)
3. Using (1) supplied IDC wire tap, connect the wires listed below
and crimp the IDC wire tap in place using pliers. Ensure that a
complete and secure connection is made. Refer to FIGURE
HH & II for proper connector and pin location.
2010 MODELS
I
K
L J
VIEW FROM HARNESS SIDE
FIGURE II
VEHICLE'S KEY-IN SENSE WIRE
2010 MODELS
BROWN (SMART-KEY)
ORANGE/BLACK (RETRACTABLE KEY)
2007-2009 MODELS
BROWN/GREEN (SMART-KEY)
RED/BLACK (RETRACTABLE KEY)
NOTE: Refer to Page 2 for IDC Wire Tap Procedure and Wire color code information.
! CAUTION: BE EXTREMELY CARE-
E C A
G
BR
O/B
H F D B
Wire Tie
FIGURE GG
FIGURE HH
2007-2009 MODELS
K I G E C
Y/G R W/G B/L
BR/G
L J H F D
B/G R
VIEW FROM HARNESS SIDE
REMOTE START HARNESS WIRE
RED/BLACK
RED/BLACK
11
Yellow Shielded
Harness
A
R/B R
B
R
4280246 Rev. B 11/10
Wire Tie