Troubleshooting
If...
You cannot take a
picture
Picture orientation is
not accurate
Flash does not fire
Battery life is short
Picture taken does not
appear as framed in
viewfinder
Computer/connectivity problems
If...
The computer does
not communicate with
the camera
Slide Show does not
run on an external
video device
35
Try one or more of the following
■
Turn the camera off, then on again.
■
Depress the Shutter button all the way
■
Insert new batteries. If using rechargeable batteries,
charge before inserting
■
Wait until the ready light is green before attempting to
take another picture.
■
Transfer pictures to the computer
pictures from the camera
locations
(page
memory
(page
7).
■
Set the Orientation Sensor
■
Check flash setting, and change as needed (see
■
Wipe the contacts with a clean, dry cloth
loading batteries in the camera.
■
Insert new batteries. If using rechargeable batteries,
charge before inserting
■
For best results (especially in Close-up mode or when
using zoom) use the camera screen to frame your subject
(page
10).
Try one or more of the following
■
Turn on the camera.
■
Insert new batteries. If using rechargeable batteries,
charge before inserting
■
Make sure USB cable is securely connected on camera and
computer port
(page
■
Make sure the EasyShare software is installed
■
Adjust the camera Video Out setting (NTSC or PAL,
page
18).
■
Make sure the external device settings are correct (see the
device's user's guide).
(page 2
and
(page
(page
21), switch image storage
15), or insert a card with available
(page
18).
(page 2
and
(page 2
and
32).
(page
8).
page
3).
32), delete
page
12).
(page
3) before
page
3).
page
3).
(page
27).