Kodak EasyShare Z1485 IS Extended User Manual page 57

Camera ready light status
If
Ready light does
not turn on and the
camera does not
work.
Ready light blinks
green.
Ready light blinks
amber.
Ready light blinks
red and camera
turns off.
Ready light glows
steady red.
Ready light is off or
glows steady
green.
Camera/computer communications
If
Cannot transfer pictures.
(The Add New Hardware Wizard
cannot locate drivers.)
www.kodak.com/go/support
Try one or more of the following
■
Turn on the camera
■
Install new batteries
the user documentation that accompanies your charger, dock, etc.)
■
Turn camera off, then back on.
■
Camera is operating normally.
■
Wait. Resume picture taking when the light stops blinking and turns
green.
■
Install new batteries
the user documentation that accompanies your charger, dock, etc.)
■
Transfer pictures to the computer
camera (page 15), switch image storage locations
a card with available memory
■
Wait. Resume picture taking when the light turns off.
■
Change the image storage location to internal memory
use a different card.
■
Camera is operating normally.
Try one or more of the following
■
■
(page 2).
(page 1) or charge rechargeable batteries. (See
(page 1) or charge rechargeable batteries. (See
(page
(page
Disconnect USB cable. (If using camera dock or printer
dock, disconnect cable and remove camera from
dock). Close all open applications. Re-install the
software (page 43).
Disconnect the USB cable. Close all open applications.
Re-install the software
Troubleshooting
44), delete pictures from the
(page
3).
(page
(page 43).
30), or insert
30), or
51