Kodak EasyShare Z1485 IS Extended User Manual page 55

If
In Review mode, a
blue or black
screen is displayed
instead of a
picture.
Shutter button
does not work.
Slide show does
not run on external
video device.
Picture is too light.
Picture is not clear.
Picture is too dark.
www.kodak.com/go/support
Try one or more of the following
■
Transfer the picture to the computer
internal memory
Caution: Formatting a card deletes all pictures and videos,
including protected files.
■
Turn on the camera
■
Wait until the Ready light stops blinking red before attempting to take
another picture.
■
Transfer pictures to the computer
camera (page 15), switch image storage locations
a card with available memory
■
Adjust the camera Video Out setting (NTSC or PAL,
■
See the external device's user's guide.
■
Move so there is at least 2 ft (0.6 m) between the camera and the
subject.
■
Decrease Exposure Compensation
■
Clean the lens (page
■
Make sure your camera is not in Close-up mode.
■
Move so there is at least 2 ft (0.6 m) between the camera and the
subject.
■
Press the shutter button halfway to focus and set exposure. When the
ready light turns green, press the Shutter button completely down.
■
Place the camera on a flat, steady surface or use a tripod.
■
Turn on the flash
■
Move so there is no more than 11.8 ft (3.6 m) in wide angle and
6.9 ft (2.1 m) in telephoto between the camera and the subject.
■
Use Fill flash (page
the subject.
■
Increase Exposure Compensation
(page
(see page 33).
(page 2).
(page
(page
(page
61).
(page 9).
9) or change your position so light is not behind
(page
Troubleshooting
44), then format the card or
44), delete pictures from the
(page
3).
see page
38).
38).
30), or insert
32).
49