ProForm 6.0 ET User Manual page 14

13. Orient the Rear Upright Cover (81) as shown.
Note: If you purchase the optional chest
heart rate monitor (see page 27), see
step 19 on page 16 to install the receiver
included with the heart rate monitor.
Tip: Avoid pinching the wires. Attach the Rear
Upright Cover (81) to the Upright (4) with four
M4 x 16mm Screws (101).
Orient the Front Upright Cover (117) as shown.
Attach the Front Upright Cover (117) around the
Upright (4) by pressing it onto the Rear Upright
Cover (81).
14. Identify the Right Upper Body Arm Front Cover
(65) and orient it as shown.
Attach the Right Upper Body Arm Front Cover
(65) to the Right Upper Body Leg (60) with two
M4 x 16mm Screws (101).
Identify the Right Upper Body Arm Rear Cover
(66) and orient it as shown.
Attach the Right Upper Body Arm Rear Cover
(66) around the Right Upper Body Leg (60) by
pressing it onto the Right Upper Body Arm Front
Cover (65).
Repeat this step on the other side of the
elliptical.
13
81
14
66
14
117
4
101
Avoid
pinching
the wires
65
60
101